HP EML E-series Tape Libraries - Manual (Page 85)

3. Tighten the captive screws in both ejector handles. Use a #1 Phillips screwdriver.
4. Plug the cables into the Interface Manager card exactly as they were plugged into the original
Interface Manager card (see the labels on the cables or the note that you wrote).
5. Turn on the power to the library.
NOTE:
Because all of the configuration settings for the Interface Manager card are stored on the
CompactFlash memory card that you moved, your new Interface Manager card retains
the configuration of the original card. To examine or change these settings, see the HP
StorageWorks Interface Manager and Command View TL user guide .
6. Make sure that the status LEDs indicate a normal state (see
“ HP StorageWorks Interface Manager card ” on page 56).
CompactFlash memory card
Part Number 342215-001
Location On the Interface Manager card
Characteristics CompactFlash memory card in a holder
Function
Stores the firmware and configuration settings for the Interface
Manager card
Illustration
To replace the CompactFlash memory card, see step 9 on page 84 of the Interface Manager card
removal procedure.
HP StorageWorks e2400-FC 2Gb interface controller
Part number 356690-001 or 416274-001
Location
In the middle slot in the base-module card cage or in any slot in
the card cage expansion module
Characteristics
Contains two HBA or switch FC ports, four tape drive FC ports,
one Ethernet port, and one serial port
Function
Manages up to four tape drives and provides bidirectional
connectivity for 2 Gbps FC interfaces
Illustration
10464
Required tools
• #1 Phillips screwdriver
Removing an e2400-FC 2Gb interface controller
1. Identify the e2400-FC 2Gb interface controller to be replaced by one of the following methods:
Enterprise Modular Library E-Series 85