HP StorageWorks XP Remote Web Console Software - Manual (Page 169)

Hitachi TrueCopy for z/OS user guide 169
• If the first digit of the cmd_param is other than A, the disk array interprets this command as pair
deletion for TC390 Synchronous or SI390.
• Regardless of the number of volume pairs to be deleted, this command ends before the actual pair
deletion is successfully completed. Confirmation by CQUERY or IEA494I console message is
recommended after this command.
CQUERY for serial interface
The CQUERY command can be issued to a TC390A pair to determine its detailed pair status as well as its
TC390A pair and group options. The following example shows the output of the CQUERY command with
the VOLUME parameter issued to a TC390A M-VOL.
NOTE: When the controller emulation type is 3990, the CQUERY command only displays the path types
and path status of the first four paths, even if more than four paths have been added.
NOTE:
•
The LIC LEVEL value in the following output is for example only, not valid number.
• The WWNN value in the following figure will be valid if mode 484 is ON. If mode 484 is OFF, the
WWNN value is example only, not valid number.
• If mode 484 is ON, the status of path as using the Fibre Channel interface will be displayed. If mode
484 is OFF, ESCON will be indicated for the path status.
• If the former type subsystem or the subsystem of XP12000/XP10000 microcode version 50-05-XX-XX or
earlier is connected, mode 484 must be OFF.
CQUERY Output Example: M-VOL/FORMAT/VOLUME
The CRIT box is not used for TC390A (NO is always indicated).
The FIRST/LAST CYL OUT OF SYNC and PERCENT OF COPY COMPLETE boxes indicate the first/last cylinder
number and percentage of cylinders (including R-VOL cylinders) to be copied for pair resynchronization.
For a more detailed description, see ” Resuming TrueCopy volume pairs (Resume Pair) ” on page 134.
The PATHS, SAID, DEST, STATUS, and DESCRIPTION fields indicate the path status for this pair. If you issue
the CQUERY command to the volume pair with the PATH parameter, all paths that can be used for this
volume pair are displayed.
************* PPRC REMOTE COPY CQUERY - VOLUME **********************
* (PRIMARY) (SECONDARY) *
* SSID CCA LSS SSID CCA LSS *
*DEVICE LEVEL STATE PATH STATUS SERIAL# SERIAL# *
*------ --------- ---------- ----------- --------- --------- *
* 2A10 PRIMARY.. PENDING... ACTIVE.. 4300 10 00 4300 11 00 *
* CRIT(NO)....... CGRPLB(NO). 00A7FS0V0000 000000099999 *
* PATHS SAID DEST STATUS: DESCRIPTION *
* ----- --------- ------ ------------------- *
* 1 aabb ccdd 01 PATH ESTABLISHED... *
* ---- ---- 00 NO PATH............ *
* ---- ---- 00 NO PATH............ *
* ---- ---- 00 NO PATH............ *
* IF STATE = PENDING/SUSPEND: TRACKS OUT OF SYNC = 47277 *
* TRACKS ON VOLUME = 50085 *
* PERCENT OF COPY COMPLETE = 6% *
* SUBSYSTEM WWNN LIC LEVEL *
* ----------- ---------------- ----------- *
* PRIMARY.... 0000000000000000 3.8.05.0000 *
*********************************************************************