HP XP Racks - Manual (Page 99)

Related topics
•
“Splitting pairs with CSUSPEND and PPRCOPY SUSPEND” (page 94) .
CDELPAIR parameters and examples
The following table describes the CDELPAIR PPRC command parameters used to delete pairs.
Description Value Parameter
NA Device number DEVN
You must use these parameters to successfully run
the command. Primary volume: SSID, serial number, channel
connection address, and CU number. PRIM
To delete all pairs in a CG, set this parameter
to MAnn0.
Note: nn is the CTG ID.
NA Secondary volume: SSID, serial number,
channel connection address, and CU number. SEC
The following image shows an example of running the CDELPAIR PPRC command:
PPRCOPY DELPAIR parameters and examples
The following table describes the PPRCOPY DELPAIR PPRCOPY command parameters used to
delete pairs.
Description Value Parameters
Only one of the three parameters should be
specified. The italic term is the arbitrary name. DDNAME = dname = JCL statement identifying
the volume. DDNAME,
SYSNAME, or
UNITADDRESS
For example, dname is the arbitrary unique
SYSNAME = sysxxx = SYSNAME in the ASSGN
system control statement.
name of the JCL statement which identifies the
volume.
UNITADDRESS = ccuu = device number.
You must use these parameters to successfully
run the command. Primary volume: SSID, serial number, channel
connection address. PRI
To delete all pairs in a CG, set this parameter to
MAnn0.
Note: nn is the CTG ID.
NA Secondary volume: SSID, serial number, channel
connection address. SEC
NA P-VOL or S-VOL CU number. LSS
The following image shows an example of running the PPRCOPY DELPAIR PPRCOPY command:
Deleting pairs with CDELPAIR and DELPAIR 99