HP XP Racks User Manual
Page 83
Description
SSB2 code
•
The pair task was rejected because the specified P-VOL and S-VOLs were a Compatible FlashCopy
pair.
•
The reverse resynchronization was rejected because the pair of the specified P-VOL and S-VOLs
is suspended (“Suspend/SUSPER” status).
•
The reverse resynchronization was rejected because the specified P-VOL and the S-VOL is the L2
pair.
•
The CG pair-split was rejected because some of the pairs in the CG were being resynchronized,
split, or were already suspended.
•
The pair task was rejected because the pair status of the P-VOL, the S-VOL, or both showed that
the pair could not receive the issued command.
The pair task was rejected because the volume you specified as the S-VOL is online to the host.
2312
The pair was not created because the volume you specified as the S-VOL is the S-VOL of another pair
that has been split (“Split/SUSPOP” status).
2314
The pair was not restored because the P-VOL of the specified pair is online to the host.
231F
The pair task was rejected because there is not a sufficient amount of installed shared memory or
initialization is not completed.
2322
The pair task was rejected because the number of slots of the volume you specified as the P-VOL
exceeded the upper limit.
2324
The pair task was rejected because the number of slots of the volume you specified as the S-VOL
exceeded the upper limit.
2325
The pair was not created because the volume you specified as the P-VOL had already had three
S-VOLs.
2326
The pair was not created because the node volume specified as the P-VOL had already had two
S-VOLs.
2327
The pair task was rejected because the pair configuration exceeded the number of the layers of the
cascade configuration.
2328
The pair task was rejected because the volume you specified as the S-VOL is the S-VOL of an existing
pair.
2329
The pair was not created because pairs that would exceed the license capacity were going to be
created.
232A
The pair task was rejected because the volume you specified as the P-VOL is allocated as the destination
of the Auto LUN.
232F
The pair task was rejected because the capacity of the specified P-VOL is not the same as the S-VOL’s.
2331
The pair was not created because the volume you specified as the P-VOL had already had three
S-VOLs.
2332
The pair task was rejected because the volume you specified as the P-VOL is not the P-VOL of the
existing pair.
2333
One of the following occurred:
2334
•
The pair task was rejected because the volume you specified as the P-VOL had an emulation type
that BCM could not handle.
For more information about pair volumes and supported emulation types, see
supported emulation types” (page 12)
•
The CG pair-split was rejected because the volume you specified as the P-VOL is an intermediate
volume.
The pair task was rejected because the volume you specified as the S-VOL had an emulation type that
could not be handled by BCM.
2335
Locating and interpreting error codes and logs using the RAID Manager or BCM
83