HP Surestore 6.140 Tape Library - Manual (Page 86)

Library Administration
Using the Remote Management Card
Chapter 3 3-12
NOTE To correctly set caching for Internet Explorer™, go to the Windows
Control Panel and select
[Internet] . Click on the [General] tab. In the
Temporary Internet Files section, click on the [Settings] button. Select
[Every Visit to the Page] , and click on the [OK] buttons to exit. (Netscape
Communicator™ and Netscape Navigator™ set caching automatically.)
Configuring the Remote Management Card
The library only requires one remote management card, which will
already be installed when the library arrives.
NOTE The library administrator password is required for this process. If the
password is not set, you will not be permitted to configure your remote
management card from your web browser. (See “Enabling and Changing
the Password” on page 3-5.)
1. Connect to the network port of the card using a category 5 ethernet
cable. Ensure that the cable is also connected to an active network
port.
2. On the library’s back panel, verify that the link LED on the remote
management card is green. If the LED is not green, a link has not
been established with the local network. Ensure the network port is
active by checking with your system administrator. (See “Interpreting
Library LEDs” on page 4-17 for a description of the LEDs.)
3. Enter the Network Access menu.
Main Menu ->
Administration ->
Change Configuration ->
Network Access