HP Surestore 6.140 Tape Library - Manual (Page 41)

Getting Started
Configuring the Host System
Chapter 1 1-25
G
e
ttin
g
S
tar
te
d
NOTE HP C7200-8000 is used only as an example. The actual ioscan output will
reflect the product number of the library you are configuring.
HSC or PCI Pass-Through Driver Installation
The following procedure assumes the use of a SAM terminal mode. In X-
windows (GUI) mode, use the mouse button to select an option.
1. Run SAM.
2. Select Kernel Config , and press Return .
3. Select Drivers , and press Return .
4. Select sctl .
NOTE If Current State is “In,” proceed to “Creating a Device File for the Robotics
Controller”. Otherwise, continue with the next step.
5. From the Menu Bar, select Actions . Select Add Drivers to
Kernel , and press Return .
6. From the Menu Bar, select Actions . Select Create New Kernel ,
and press Return .
7. At the Are you sure prompt, respond Yes. Press Return .
8. After the status messages, select OK . Press Return . The system
reboots.
Creating a Device File for the Robotics Controller
1. Use the mknod command to create a device file to access the robotics
controller. The command syntax is:
/user/sbin/mknod /dev/scsi/ c
• < devfilename > is the user-defined name of the device file.
• < majornum > is the character major number from the lsdev
command.
• < minornum > is the minor number in the format 0xIITL00 ; where
II is the two-digit card instance number in hexadecimal; T is the
target SCSI ID number; L is the LUN number, and 00 is reserved.