HP Surestore 6.140 Tape Library - Manual (Page 79)

Library Administration
Enabling and Changing the Password
Chapter 3 3-5
Li
b
ra
ry Ad
mi
ni
s
trat
ion
Enabling and Changing the Password
NOTE Administration procedures can be password protected. These procedures
include: diagnostic tests, configurations, online drive repair, and setting
the date and time. A password is also required for administration through
the remote management card.
When the library is first installed, the password is inactive. To protect
the system from unauthorized access, use the following procedure to set
a password.
1. Enter the Password menu. A status screen will indicate if a password
is enabled.
• If the password is turned off, select Set New Password to enable the
password.
• If the password is turned on, select Change Password to enter the
new password. It must be exactly eight digits.
• If the password is turned on, select Turn Password Off to clear the
password.
NOTE If you enter more than eight digits, the ninth digit will become the first
digit of the new password.
2. Select [OK] to exit.
CAUTION Be sure to document the password. If you forget the password, contact
your service representative.
Main Menu ->
Administration ->
Change Configuration ->
Password