HP Surestore 6.140 Tape Library - Manual (Page 35)

Getting Started
Installing the Library (for Authorized Service Personnel only)
Chapter 1 1-19
G
e
ttin
g
S
tar
te
d
WARNING
Note the high leakage label on the back of the library before connecting power to
the library.
NOTE The AC power cord is the library’s main AC disconnect device and must
be easily accessible at all times.
7. Connect the power cord from the power distribution unit to a
grounded power receptacle, and power on the library. The power
(standby) switch is recessed and on the lowest level on the front of the
library.
After the power-up test is complete (after several minutes), you will
see the Home Screen on the library’s front panel. The Home Screen
displays the status of the drives and library. See “Front Panel Status
Information (Home Screen)” on page 2-5.
8. From the front panel, configure the library for Fibre Channel. See
“Configuring the Library for Fibre Channel” on page 3-15 for more
information.
9. Connect the remote management card (see “Using the Remote
Management Card” on page 3-9).
10. Power on the host.