HP Surestore 6.140 Tape Library - Manual (Page 135)

Understanding Errors and Troubleshooting
Troubleshooting Common Problems
Chapter 4 4-29
E
rr
o
rs
&
T
roub
le
sh
oo
ti
ng
The library’s power failed
while a tape was in the
drive and did not return to
the ready state after the
power came on. • Verify that the LEDs on the back of the library are on and
that the fans are turning (see page 4-17).
• Power cycle the library.
• Contact your service representative.
No display messages
appear. • Make sure the power cord is connected.
• Make sure the power switch is on.
• Check that the LEDs on the back of the library are on and
the fans are turning (see page 4-17).
• Power cycle the library.
• Try to access the library from the web (see page 3-9).
• Download library firmware (see page 4-60).
• Contact your service representative.
Tape Movement
An error message appears
after inserting the
magazine or loading tapes. • Verify that tapes are inserted correctly in the magazine.
(See page 2-11).
• Verify that the correct tape type is used. (See Appendix
D.)
Tape stuck in drive. • Power cycle the library and retry unloading the tape from
the library front panel.
• Ensure the backup host software is not reserving the slot.
The backup software needs to cancel the reservation.
• See Appendix D for additional information on removing a
stuck tape.
• Contact your service representative.
Tape stuck in transport. • Run the Recalibrate Library test (see page 3-29).
• Power cycle the library.
• Contact your service representative.
Table 4-12 Troubleshooting Table
Problem Solution