HP Surestore 6.140 Tape Library - Manual (Page 49)

Getting Started
Identifying the Post-Installation Tasks
Chapter 1 1-33
G
e
ttin
g
S
tar
te
d
Identifying the Post-Installation Tasks
After you install and configure the library, you must complete the
following setup tasks from the library’s front panel:
• Setting the date and time: When you first set up the library or if it
has been disconnected for an extended period of time (around 8 days),
you must set the library’s real-time clock. See “Setting the Date and
Time” on page 3-22 for more information.
• Setting the mailslot configuration: The default setting is for a
one-slot mailslot. You can select a 0, 1, 5, or 10-slot mailslot. See
“Configuring the Mailslot” on page 3-6 for more information.
• Configuring the library for web monitoring: You can monitor
and manage your library anywhere on the network through user-
friendly web pages. See “Using the Remote Management Card” on
page 3-9 for more information.
• Enabling the password: The library does not have a password
enabled when it arrives. To ensure security, enable and select a
password. Be sure to document this password. See “Enabling and
Changing the Password” on page 3-5 for more information.
NOTE You must first set a library password through the front panel to configure
the library using the remote management card (see “Enabling and
Changing the Password” on page 3-5).