Crosshair cursor size, Save 4014 graphics display, Set tek graphics height – HP Neoware e140 Thin Client User Manual
Page 314: Set tek graphics width
20-18
Initialization Commands
Crosshair Cursor Size
Registry Entry:
CrosshairSize = 1-1024
Command Line: -X1-1024
Default Setting: 1024
Only applicable to versions of TeemTalk that support graphics emulations. This
command specifies the size of the graphics cursor, where size is a numeric value in the
range 1 to 1024, i.e. world coordinates.
Save 4014 Graphics Display
Registry Entry:
SaveTekImage = “on”
Command Line: -P
Default Setting: off
Only applicable to versions of TeemTalk that support graphics emulations. This
specifies that the 4014 graphics display is saved when you switch to alpha mode so
that it is restored when you switch back to graphics mode.
Set Tek Graphics Height
Registry Entry:
GraphicsHeight =
Command Line: -GH
Default Setting: Not applicable
Only applicable to versions of TeemTalk that support graphics emulations. This
specifies the height of the Tek graphics area in pixels.
Set Tek Graphics Width
Registry Entry:
GraphicsWidth =
Command Line: -GW
Default Setting: Not applicable
Only applicable to versions of TeemTalk that support graphics emulations. This
specifies the width of the Tek graphics area in pixels.