HP Neoware e140 Thin Client - Manual (Page 18)

2-2
Getting Started
4. Enter a name which will identify this session configuration for future selection in
the Connection Name box.
5. Select the terminal emulation required in the Emulation list box.
6. If additional configuration options are displayed, make the relevant selections.
Refer to the Terminal Emulation Configuration section later in this chapter for
details.
Clicking the International Settings button will display keyboard language and
character set options for the selected terminal emulation. Refer to the relevant
emulation settings dialog box description in the Setup Menus chapter for details.
(Note that the DEC VT options are located in the Emulation and Terminal
Settings dialog boxes.)
7. Click Next to display the Host Information dialog box.
For a TCP/IP connection, click the TCP/IP button and enter the name or internet
address of the host computer in the Host Name box. Selecting the Host Rollover
On Connection Fail option will present four Host Name entry boxes. The
emulator will attempt to connect to each specified host in turn until one is success-
ful. Click Advanced for Telnet options. Refer to the TCP/IP Connection Settings
section later in this chapter for details.
For a modem connection, click the Modem button then click Advanced to display
configuration options. Refer to the Modem Connection Settings section later in this
chapter for details.
For a serial connection, click the Serial button, specify the communications port in
the Connect To box, then click Advanced for additional serial options. Refer to
the Serial Connection Settings section later in this chapter for details.