Host connection, Action on host connection close, New session warning message – HP Neoware e140 Thin Client User Manual
Page 301: Preload winsock dll for ppp usage, Host connection -5, Load winsock on start-up, Disable new session warning message box
20-5
Initialization Commands
Host Connection
Load Winsock On Start-up
Registry Entry:
None
Command Line: -LW
Default Setting: Off
This will initialize the Winsock stack immediately when the emulator is started,
enabling dialup over PPP or SLIP to gain a connection to a service provider.
Action On Host Connection Close
Registry Entry:
ExitOnClose = "on"
emulator exits immediately
ExitOnClose = "off"
emulator does not exit
ExitOnClose = "connect" emulator attempts to
reconnect
Command Line: -E
emulator exits immediately
-E1
emulator does not exit
-E2
emulator attempts to reconnect
Default Setting: Message box displayed
When the host closes the connection or the connection fails, the emulator normally
displays a message box giving you the option to reconnect, cancel or exit. These
commands will disable the message box and cause the emulator to immediately
perform the required option.
Disable New Session Warning Message Box
Registry Entry:
SessionWarning = "off"
Command Line: -OS
Default Setting: Enabled
A warning message is displayed by default when you attempt to open a new session
while a session is currently open. These commands enable you to disable the message
box so that the emulator automatically closes the current session and opens the new
session.