HP Neoware e140 Thin Client - Manual (Page 293)

19-3
Wyse Emulations
The TVI 910+, TVI 920 and TVI 925 emulations provide compatibility with
software designed to drive the TeleVideo 910+, 920 and 925 terminals, respec-
tively, as emulated by the Wyse WY-50/50+/60 terminals.
3. Display the File menu from the command bar and select New Connection to
display the New Connection dialog box.
4. Select the type of host connection required in the Type list box.
For a TCP/IP connection, select TCP/IP, enter the name or internet address of the
host computer in the Connect To box, then click Configure for additional Telnet
options. Refer to the TCP/IP Connection Settings section in chapter 2 for details.
For a modem connection, select Modem, specify the communications port in the
Connect To box, then click Configure to display configuration options. Refer to
the Modem Connection Settings section in chapter 2 for details.
For a serial connection, select Serial, specify the communications port in the
Connect To box, then click Configure for additional serial options. Refer to the
Serial Connection Settings section in chapter 2 for details.
5. When you have specified the required settings in the New Connection dialog box,
click the Connect button to make the connection.
Note: You can save these settings as a connection template using
the Save Session As dialog box. Refer to the Setup Menus
chapter for details.
All the Wyse associated emulations are configured via the Wyse Settings dialog box
which is described in the Setup Menus chapter. Note that some settings may not apply
to the particular emulation currently running. Selecting a setting that is not applicable
to the current emulation will cause the emulator to use the default setting for that
emulation when the dialog box is exited.