Initialization commands, Introduction, Initialization commands -1 – HP Neoware e140 Thin Client User Manual
Page 297: Introduction -1
20-1
Initialization Commands
20
Initialization Commands
This chapter describes all the initialization commands that can be
included in the registry or on the command line to run the emulator.
Introduction
This chapter describes the registry entries and command line options that can be used
to specify how the emulator is initially run.
Registry entries for the emulator are read from a registry key under
HKLM\Software\Pericom\
Startup,NAME (where NAME is specified using the -N command line option).
Command line options are used to modify the configuration of the emulator on start-
up. They are entered after the name of the emulator and each option must be preceded
by a space. An option is immediately followed by its setting if one is required, without
a space in between.
The following section provides a summary of all the registry entries and command line
options supported by the emulator. This is followed by sections describing the
commands in detail, grouped according to their function.