HP Neoware e140 Thin Client - Manual (Page 126)

6-42
Setup Menus
Auto LF
Factory default: Unselected
The setting of this option in conjunction with that of the Auto New Line option
determines the destination of the cursor when the Return key is pressed or the CR
character is received.
When both this and the Auto New Line options are unselected, the cursor will move
to the first position of the current line when the Return key is pressed or the CR
character is received.
When this is unselected and Auto New Line is selected, the cursor will move to the
first position of the next line when the Return key is pressed.
When this is selected and Auto New Line is unselected, the cursor will move to the
first position of the next line when the Return key is pressed or the CR character is
received.
When both this and the Auto New Line options are selected, the cursor will move to
the first position of the line after the next line when the Return key is pressed.
Auto New Line
Factory default: Unselected
The setting of this option determines the effect of pressing the Return key.
When unselected, the Return key will generate a CR (carriage return) character.
When selected, the Return key will generate a CR and an LF (line feed) character.
Terminal ID
Factory default: Unspecified
This specifies what is reported back to the host in response to a terminal identification
request. The terminal ID can be up to 20 characters long. (Note that not all features of
the specified terminal may be supported.)
Model
Factory default: 11
This option identifies the terminal model being emulated in response to a terminal
identification request from the host. Model 11 supports only one viewport containing
24 or 25 rows and 80 columns. Model 31 supports up to three viewports (80 or 132
columns wide) and pass-through printing.