HP Neoware e140 Thin Client - Manual (Page 287)

18-3
Unisys T27 Emulation
The Status Bar
LTIA On: The host connection is active, but the Unisys T27
emulation does not have an active address.
Off: No line activity; or the Unisys T27 emulation
transmitted a character to the host, or the user
pressed LOCAL.
Blink: The host connection is active and the Unisys
T27 emulation has an active address.
ENQUIRY On: The host is unable to send a message to the keyboard
environment, press RCV to enable the keyboard
environment to receive data.
Off: The DCP (data comm pointer) page went into receive
mode; or the user pressed LOCAL.
LOCAL On: The user pressed LOCAL; or the user pressed a key
when the cursor and the DCP (data comm pointer)
were in the same page.
Off: The Unisys T27 emulation is switched to transmit
or receive mode.
RCV On: The keyboard environment is in receive mode (ready
to receive data) or is receiving data from the host; or
FSL, GSL, BSL was received while the T27 was in
transmit or local mode and the Fast Select enabled
option is selected in the Unisys T27 Settings dialog
box.
Off: Data has been received successfully; or the T27 went
into transmit mode by use of XMIT or SPCFY; or
the cursor and DCP are in the same page upon data
entry.
XMIT On: The keyboard environment is transmitting data to the
host or is ready to transmit data.