HP Neoware e140 Thin Client - Manual (Page 267)

15-1
PT250 Emulation
15
PT250 Emulation
This chapter describes the Prime PT250 terminal emulation.
Session Configuration
WBT Mode
This section describes the basic procedure for creating a session configuration when
the terminal is in WBT mode. The options available are described in detail in chapter
2.
1. Click the Configure tab in the Terminal Connection Manager then click the
Add button to display the New Connection dialog box.
2. Select Terminal Emulation Client and click OK. The Terminal Emulation
Client Connection Wizard - Connection Information dialog box will be
displayed.
3. Enter a name which will identify this session configuration for future selection in
the Connection Name box.
4. Select the PT250 terminal emulation in the Emulation list box.
5. Click Next to display the Host Information dialog box.
For a TCP/IP connection, click the TCP/IP button, enter the name or internet
address of the host computer in the Host Name box, then click Advanced for
additional Telnet options. Refer to the TCP/IP Connection Settings section in
chapter 2 for details.
For a modem connection, click the Modem button then click Advanced to display
configuration options. Refer to the Modem Connection Settings section in chapter
2 for details.
For a serial connection, click the Serial button, specify the communications port in
the Connect To box, then click Advanced for additional serial options. Refer to
the Serial Connection Settings section in chapter 2 for details.