HP Neoware e140 Thin Client - Manual (Page 145)

6-61
Setup Menus
Unisys T27 Settings
This dialog box is displayed by selecting Unisys T27 in the Settings menu.
General Settings
Protocol
Factory default: None
This can be set to None, Poll/Select or Point to Point.
Selecting Poll/Select will enable up to three environments. Only one environment can
be enabled when Point to Point is selected.
Tx Number
Factory default: 0
This specifies a sequence of numbers to ensure correct sequencing of messages sent
between the Unisys T27 emulation and the host. The valid numbers are as follows:
00 None
01 0/1 no checking
02 @/A no checking
03 0/1 checking
04 @/A checking
05 0/1, with * reset
06 @/A with * reset
07 0-9
08 0-99
09 0-999
10 0-9 with * reset
11 0-99 with * reset
12 0-999 with * reset
The * reset option enables the host or the Unisys T27 emulation to resequence by
sending an asterisk, for example, after a system failure, to ensure synchronization.