HP Neoware e140 Thin Client - Manual (Page 254)

12-10
IBM 5250 Emulation
2. Press the Fn key which will store the keystrokes. (On 101/102 keyboards you can
also use Shift + Fn.)
The status line will display R**** F* where R indicates you are in Record mode,
**** is the number of keystrokes that may be stored, and F* is the number of the
Fn key pressed.
Note: If you press a pre-recorded Fn key, its contents will be
replaced with the following keystrokes. You can also remove
the contents of the Fn key before recording by pressing the
Delete key.
3. Enter the keystrokes to be recorded. You may pause recording at any time to allow
keystrokes to be entered manually when played back by pressing Pause. Pause
mode is indicated by R ^. To continue recording, press Pause again.
Note: You can cancel the newly recorded keystrokes by pressing the
Quit key. This cancellation does not affect the previously
recorded keystrokes.
4. To finish and save the recording, press the Record key.
Playback Keystrokes
1. Position the text cursor where the playback is to start.
2. Press the Play key to enter Play mode.
The status line will display PLAY and a series of boxes representing the Fn keys.
A solid box indicates that the Fn key in that position is currently storing recorded
keystrokes.
3. Press the Fn key storing the recorded data to play back.
Playback will begin immediately, as indicated by a P on the status line. All the
recorded keystrokes will be played back automatically. When playback is com-
pleted the P will disappear.
If the recorded keystrokes included Pause, then playback will halt at that point to
allow you to enter keystrokes manually. Press Play to resume playback from
where you stopped typing.
If you want to cancel during the playback operation, press the Quit key.
Error Codes
The following error codes may appear on the status line if an error occurs during
recording or playback.