HP Neoware e140 Thin Client - Manual (Page 124)

6-40
Setup Menus
Note that the contents of the display will be cleared when you change the display
format.
Turnaround Char
Factory default: CR
This option specifies the line turnaround character (LTC) that is generated when a
Read command is received or one of the block data transmission keys is pressed. Note
that selecting DC3 will disable the XON/XOFF inbound and outbound pacing
characters.
Forcing Insert
Factory default: Both
This option specifies how an insert command affects displayed data when the screen is
full.
When set to Off, you will not be able to perform an insert operation.
When set to Line, you will be able to insert one or more lines, using the Ins Ln key for
example. The contents of the current and all following lines will move down the
number of lines inserted, causing the lines originally at the bottom of the display to be
discarded.
When set to Character, you will be able to insert one or more characters in the current
line. Characters to the right of the cursor position will move along. If the Auto Wrap
option is set to No, then characters originally at the end of the current line will be
discarded. If set to Yes, characters on all following lines will move along, forcing
characters at the end of the last line to be discarded.
When set to Both, the function of the Line and Character settings will be enabled.
Insert Character
Factory default: Space
The setting of this option determines the effect of pressing the Insert key.
When set to Space, a space character will be inserted after the current cursor position.
When set to Mode, the emulation will enter Insert mode when the Insert key is
pressed.
Tab Operation
Factory default: Field
The setting of this option determines whether tab stops are according to field attribute
characters or column-tab definitions.
When set to Field, tab stops in a formatted page are provided by field attribute
characters. Column-tab definitions are ignored.