HP Neoware e140 Thin Client - Manual (Page 235)

11-7
IBM 3270 Emulation
Do Not Enter
The Do Not Enter ( ) symbol will appear when input from the keyboard or mouse
will not be accepted by the host (except Reset and SysReq). Symbols to the right of
this will indicate the reason. Pressing the Reset key will remove some of these symbols
from the status line. Note that the emulation includes typeahead capability so that in
most cases you can continue to enter data without waiting for the Do Not Enter
message to clear as the data will be stored until the host is ready.
PROGnnn Indicates that a programming error in the data from the host has
been detected, possibly due to incompatible application soft-
ware. Press the Reset or SysReq key to remove this indicator
and unlock the keyboard.
Indicates that you must wait while the requested function is
performed.
NUM Indicates that you tried to enter an invalid character into a nu-
meric field when the numeric-lock feature was active. The
keyboard numeric-lock feature can be overridden by using a
Shift key. The keyboard can be unlocked and the indicator
removed by pressing the Reset key.
Indicates that you tried to enter data in the wrong location. This
will occur when you attempt to do any of the following:
Enter, insert, erase, or delete a character when the cursor is in a
protected field or at a field attribute location.
Perform a cursor-select operation when the cursor is not in a
valid cursor-select field.
The keyboard can be unlocked and the indicator removed by
pressing the Reset key.
SYSTEM Indicates that you cannot enter any data because the application
program has disabled the keyboard following an entry.
> Indicates that you attempted to insert characters into an unpro-
tected field when the cursor was at the end of the field, or you
attempted to word wrap to the next line when there were not
enough spaces to enable a word wrap.
The keyboard can be unlocked and the indicator removed by
pressing the Reset key.