HP 4000.6000.8000 Enterprise Virtual Arrays User Manual
Page 58
Figure 31 Raising a leveler foot
2. Leveler foot
1. Hex nut
3.
Carefully move the rack to the installation area and position it to provide the necessary service
areas (see
).
To stabilize the rack when it is in the final installation location:
1.
Use a wrench to lower the foot by turning the leveler foot hex nut clockwise until the caster
does not touch the floor. Repeat for the other feet.
2.
After lowering the feet, check the rack to ensure it is stable and level.
3.
Adjust the feet as necessary to ensure the rack is stable and level.
58
Enterprise Virtual Array hardware components
This manual is related to the following products: