beautypg.com

Fiber optic fibre channel cables, Copper fibre channel cables, Fibre channel disk drives – HP 4000.6000.8000 Enterprise Virtual Arrays User Manual

Page 23

background image

Fiber Optic Fibre Channel cables

The Enterprise Virtual Array uses orange, 50-µm, multi-mode, fiber optic cables for connection to
the SAN. The fiber optic cable assembly consists of two 2-m fiber optic strands and small form-factor
connectors on each end. See

Figure 9 (page 23)

.

To ensure optimum operation, the fiber optic cable components require protection from
contamination and mechanical hazards. Failure to provide this protection can cause degraded
operation. Observe the following precautions when using fiber optic cables.

To avoid breaking the fiber within the cable:

Do not kink the cable

Do not use a cable bend-radius of less than 30 mm (1.18 in)

To avoid deforming, or possibly breaking the fiber within the cable, do not place heavy objects
on the cable.

To avoid contaminating the optical connectors:

Do not touch the connectors

Never leave the connectors exposed to the air

Install a dust cover on each transceiver and fiber cable connector when they are
disconnected

If an open connector is exposed to dust, or if there is any doubt about the cleanliness of the
connector, clean the connector as described in

“Handling fiber optic cables” (page 71)

.

Figure 9 Fiber Optic Fibre Channel cable

Copper Fibre Channel cables

The Enterprise Virtual Array uses copper Fibre Channel cables to connect the drive enclosures to
each other, or to the loop switches and to the HSV controllers. The cables are available in 0.6-meter
and 2.0-meter lengths. Copper cables provide performance comparable to fiber optic cables.
Copper cable connectors differ from fiber optic small form-factor connectors (see

Figure 10 (page

23)

).

Figure 10 Copper Fibre Channel cable

Fibre Channel disk drives

The Fibre Channel disk drives are

hot-pluggable

and include the following features:

Dual-ported 2-Gbps Fibre Channel drive enclosure interface that allows up to 120 disk drives
to be supported per Fibre Channel drive enclosure pair

Compact, direct-connect design for maximum storage density and increased reliability and
signal integrity

Both online high-performance disk drives and FATA disk drives in a variety of capacities and
spindle speeds

Better vibration damping for improved performance

Fibre Channel drive enclosures

23