Entering the wwn checksum, Entering the storage system password, Installing hp p6000 command view – HP 4000.6000.8000 Enterprise Virtual Arrays User Manual
Page 17
4.
Press
or
until the first character of the WWN is displayed. Press
to accept this character
and select the next.
5.
Repeat
to enter the remaining characters.
6.
Press Enter to accept the WWN and select the checksum entry mode.
Entering the WWN checksum
The second part of the WWN entry procedure is to enter the two-character checksum, as follows.
1.
Verify that the initial WWN checksum displays 0 in both positions.
2.
Press
or
until the first checksum character is displayed. Press
to accept this character
and select the second character.
3.
Press
or
until the second character is displayed. Press Enter to accept the checksum and
exit.
4.
Verify that the default display is automatically selected. This indicates that the checksum is
valid.
NOTE:
If you enter an incorrect WWN or checksum, the system will reject the data and you must
repeat the procedure.
Entering the storage system password
The storage system password feature enables you to restrict management access to the storage
system. The password must meet the following requirements:
•
8 to 16 characters in length
•
Can include upper or lower case letters
•
Can include numbers 0 - 9
•
Can include the following characters: ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ ] ^ _ ` {
| }
•
Cannot include the following characters: space ~ \
NOTE:
You must be running HP Command View EVA 6.0 or later to use passwords of more than
eight characters. HP Command View EVA 8.0.1 is required with XCS 6.200. If you set a password
longer than eight characters, you will no longer be able to manage the storage system with an
earlier version of HP P6000 Command View. In this case, it will be necessary to clear the long
password and reenter a password of no more than eight characters.
Complete the following procedure to enter the password:
1.
Select a unique password of 8 to 16 characters.
2.
With the default menu displayed, press
three times to display System Password.
3.
Press
to display Change Password?
4.
Press Enter for yes.
The default password, AAAAAAAA~~~~~~~~, is displayed.
5.
Press
or
to select the desired character.
6.
Press
to accept this character and select the next character.
7.
Repeat the process to enter the remaining password characters.
8.
Press Enter to enter the password and return to the default display.
Installing HP P6000 Command View
HP P6000 Command View is installed on a management server. Installation may be skipped if
the latest version of HP P6000 Command View is running. Verify the latest version at the HP website:
Procedures for getting started
17