AMX Modero NXD-CV5 - Manual (Page 78)

Firmware Pages and Descriptions
66 NXD-CV5 5" Modero Wall/Flush Mount Touch Panel
Protected Setup Navigation Buttons
The Protected Setup Navigation Buttons (FIG. 61) appear on the left of the panel screen when the Protected
Setup page is currently active.
Protected Setup Page
The Protected Setup page (FIG. 62) centers around the properties used by the panel to properly communicate
with the NetLinx Master. Enter the factory default password (1988) into the password keypad to access this
page.
The elements of the Protected Setup page are described in the table below:
FIG. 61 Protected Setup Navigation Buttons
FIG. 62 Protected Setup page-showing default values
Protected Setup Page Elements
Back: Saves the changes and returns you to the previously active touch panel page.
Connection Status icon: This visual display of the connection status allows the user to have a current
visual update of the panel’s connection status regardless of what page is
currently active.
• A Lock only appears on the icon if the panel has established a connection
with a currently secured target Master (requiring a username and password).
Device Number: Opens a keypad that is used to set and display the current device number.
Press to access the System Settings page where you can configure
communication settings for the NetLinx Master and the panel.
Press to access the G4 Web Control page where you can enable or disable remot
Press to access the Tools menu and select either, Panel Logs, Panel Statistics, o
Press to access the Calibration page where you can calibrate the panel.
display and control of the panel via a web-enabled PC running a VNC client.
Connection Utility.
Press to access the Other Settings menu and select either Cache or
Passwords.
Press the Sensors button to access the Sensors Setup page where you can
modify/monitor both the light and motion sensor settings.
Provides access to the panel
firmware pages by enabling the
- Setup page (after a 3 second
- Calibration page (after a 6 second
grey front setup access button:
press/hold)
press/hold)