AMX Modero NXD-CV5 - Manual (Page 14)

Introduction
2 NXD-CV5 5" Modero Wall/Flush Mount Touch Panel
CV5 panels feature programmable firmware that can be upgraded via either the Ethernet port or the
mini-USB port.
CV5 Specifications
The following table outlines the specifications for the 5" Widescreen Modero panel.
Product Specifications
Dimensions (HWD): • NXA-RK5 (optional): metal rack-mount with black matte finish:
(3 RU - rack units high)
5.22" x 19.0" x 0.50" (13.26 cm x 48.26 cm x 1.27 cm)
• NXD-CV5 (with faceplate): 4.15" x 5.59" x 3.23"
(10.50 cm x 14.20 cm x 8.20 cm)
• CB-TP5 Rough-In/Wallbox (optional): 4.27" x 5.14" x 3.40"
(10.86 cm x 13.06 cm x 8.64 cm)
Power Requirements
(stand-alone CV5): • Constant current draw: 650 mA @ 12 VDC
• Startup current draw: 1.3 A @ 12 VDC
Memory (factory default): • 64 MB SDRAM
• 64 MB Flash Memory (not upgradeable - factory programmed)
Weight: • 1.76 lbs (0.80 kg)
Certifications: • FCC Part 15 Class B, CE, and IEC 60950
Panel LCD Parameters: • Aspect ratio: 16 x 9
• Brightness (luminance): 170 cd/m
2
• Channel transparency: 8-bit Alpha blending
• Contrast ratio: 250:1
• Display colors: 256 thousand colors (18-bit color depth)
• Dot/pixel pitch: 0.14 mm
• Panel type: TFT Color Active-Matrix
• Screen resolution: 800 x 480 pixels (HV) @ 60 Hz frame frequency
• Video format: NTSC, MPAL, PAL, and SECAM
• Viewing dimensions: 4.3" x 2.58" (109.2 mm x 65.2 mm)
Active Screen Area: • 4.25” x 2.55” (10.80cm x 6.48cm)
Viewing Angles: • 90° total viewing angle:
- Horizontal: + 45° (left and right from center)
IR Reception Angle: • Horizontal: + 25° (left and right from center)
• Vertical: + 15° (up and down from center)
Supported Audio Sample
Rates: • 48000Hz, 44100Hz, 32000Hz, 24000Hz, 22050Hz, 16000Hz, 12000Hz,
11025Hz, and 8000Hz.
Front Panel Components:
Light sensor: • Photosensitive light detector for automatic adjustment of the panel brightness
(a dim room results in a dimmer LCD display, and a bright room results in a
brighter LCD display).
Note: The light sensor can be adjusted via the Sensor Setup page (page 72).
Motion sensor (PIR): • Proximity Infrared Detector to wake the panel when the panel is approached.
• Activation range: + 25° (left and right from center) and + 15° (up and down
from center).
Note: This sensor can be adjusted via the Sensor Setup page (see page 72).
IR Receiver: • IR reception 38 KHz and 455 KHz IR frequencies.
• The IR receiver is located beneath the translucent Front Setup button. When
an IR code is detected it is sent to the NetLinx Master as a push on the
appropriate AMX IR channel.
• IR receivers and transmitters on G4 panels share the device address number
of the panel.