AMX Modero NXD-CV5 User Manual
Page 35
Installation
23
NXD-CV5 5" Modero Wall/Flush Mount Touch Panel
5.
Connect all data and power wiring connectors to their corresponding locations along the left side of the
(un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to a power source before plugging
in the 2-pin power connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.
6.
Test the incoming wiring by connecting the panel connections to their terminal locations and applying
power. Verify that the panel is receiving power and functioning properly before finalizing the installation.
7.
Disconnect the terminal end of the power cable from the power supply.
8.
Carefully slide the main unit into the cutout until the Mounting Tabs of the CV5 unit lie flush against the
wall.
9.
Insert and secure three #4 Mounting Screws (not included) into their corresponding holes located along
the sides of the NXD-CV5 (using a grounded Phillips-head screwdriver) until the unit is secure and flush
against the wall (FIG. 21).
10.
Place the Faceplate/Trim Ring assembly (A in FIG. 21) back onto the main NXD unit
(B in FIG. 21). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their
respective openings on the front bezel/faceplate.
11.
Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective
locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.
12.
Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
FIG. 21
Wall Mount panel installation configuration for flat surfaces
B - Main CV5 unit
Install the three #4 Mounting Screws
Flat installation surface
A - Faceplate/Trim Ring
Mounting Tab
Attachment is done
along the edges
of the cutout
(not included) into these three holes
(suggested length of screws is 0.25")
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the necessary connectors before being inserted into the solid surface.