AMX Modero NXD-CV5 User Manual

Page 25

Installation

NXD-CV5 5" Modero Wall/Flush Mount Touch Panel

From along the internal surface of the Faceplate, install the six buttons by firmly inserting them into the
button openings until the Button latch secures the button in place (FIG. 11).

Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of the
Faceplate (made available by the removal of the previous Trim Ring).

Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of the
internal Faceplate (FIG. 12).

Firmly press down around the Button Trim Ring until all of the latches are securely inserted into their
openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify the Button Trim Ring is
firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring and the outer surface
of the Faceplate.

Place the Faceplate back onto the main NXD-CV5 unit. Make sure to align the Microphone, Light, and
PIR Motion sensor locations on the main unit to their respective openings on the Faceplate assembly.

FIG. 11

Removing the No-Button Trim Ring

FIG. 12

Inserting the Button Trim Ring

No-Button Trim Ring

Trim

Faceplate

CV5 Panel/enclosure

Ring

Latches

(outside surface shown)

Button latch

Button installation

(showing the internal surface of Faceplate)

Button openings

Button Trim Ring

Faceplate (outer surface shown)