AMX Modero NXD-CV5 User Manual
Page 32
Installation
20
NXD-CV5 5" Modero Wall/Flush Mount Touch Panel
4.
Thread the incoming power, RJ-45, Ethernet, USB, and any optional audio/video wiring (from their
terminal locations) through the surface opening. Leave enough slack in the wiring to accommodate any
re-positioning of the panel.
5.
Connect all data and power wiring connectors to their corresponding locations along the left side of the
(un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to a power source before plugging
in the 2-pin power connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.
FIG. 18
NXD-CV5 Wall Mount panel dimensions using expansion clips