NORD Drivesystems BU0500 - Manual (Page 65)

3 Displays and control
BU 0500 GB-1013 65
3.3 SimpleBox, SK CSX-0
This option is used as a simple parameterisation, display and
control tool for the frequency inverter SK 5xxE. even in active
BUS operation, data can be read out and parameterisation made
especially if the frequency inverter slot is occupied with a BUS
unit.
Features
• 4-digit, 7-segment LED display
• Single button operation of the frequency inverter
• Display of the active parameter set and operating value
After the SimpleBox has been attached, the cable connectors
plugged in and the mains has been switched on, horizontal lines
appear in the 4-digit 7-segment display. This display signals the
operational readiness of the frequency inverter.
If a jog frequency value is pre-set in parameter P113, or a
minimum frequency is pre-set in P104, the display flashes with
this value.
If the frequency inverter is enabled, the display changes
automatically to the operating value selected in parameter
>Selection Display value< P001 (factory setting = current
frequency).
The actual parameter set is shown by the 2 LEDs next to the
display on the left in binary code.
Fig. 10 SimpleBox SK CSX-0
NOTICE Parallel operation of control elements
The SimpleBox SK CSX 0 must not be used in combination with the SK TU3-POT, SK TU3-CTR, SK TU3-PAR,
the handheld control units SK …- 3H or their built-in versions SK …-3E or the Remote control window of the
NORD CON software. As all of these elements use the same communication channel, this may cause
communication errors.
Assembly
The SimpleBox can be attached to any technology unit (SK TU3-…) or to the blind cover. To remove
it, simply pull it off after the RJ12 connection has been detached (press in the latching lever on the
RJ12 connector).
Connection
The SimpleBox is connected to the socket at the upper
edge of the frequency inverter using the RJ12
connector/cable.
The Bus termination resistor for the RS485 interface
must be set with DIP switch 1 (left).
RJ12
2 x RJ45, not with
SK 500E/505E/510E
X11 X10 X9
Fig. 11 Top side of FI with RJ12 /
RJ45 connection