Setting for dc v – KYORITSU 6310 Instruction Manual User Manual
Page 59
KEW6310 4.2.1 Basic Setting
KEW6310
4.18
Setting for DC V
Setting for Voltage Range at analogue input terminal can be made according to the procedure below.
50mV 500mV 5V
* Default value (or after system reset) : 5V
1
Press the
Cursor
Keys and select [DC V], and then press the
ENTER
Key.
2
Press the
Cursor
Keys and select a DC Range to be used, and then press the
ENTER
Key.
3
Press the
Cursor
Keys and select DC Range for 2ch, and make settings in the
same
way.
Drop down list appears.
DC Range selected for 1ch is displayed.
See also other documents in the category KYORITSU Tools:
- 1009 (13 pages)
- 1011 (12 pages)
- 1012 (12 pages)
- 1018 (1 page)
- 1030 (1 page)
- 1061 (58 pages)
- 1051 (40 pages)
- 1109S (36 pages)
- 1110 (1 page)
- 2000 (1 page)
- 2002PA (27 pages)
- 2007A (1 page)
- 2009R (33 pages)
- 2012R (2 pages)
- 2017 (1 page)
- 2031 (1 page)
- 2033 (9 pages)
- 2040 (2 pages)
- 2046R (2 pages)
- 2200 (3 pages)
- 2210R (1 page)
- 2300R (1 page)
- 2413F (24 pages)
- 2413R (24 pages)
- 2431 (2 pages)
- 2432 (1 page)
- 2433R (1 page)
- 2434 (10 pages)
- 2500 (1 page)
- 2608A (2 pages)
- 3005A (24 pages)
- 3021 (24 pages)
- 3121A (12 pages)
- 3126 (28 pages)
- 3127 (60 pages)
- 3128 (88 pages)
- 3131A (20 pages)
- 3132A (20 pages)
- 3161A (24 pages)
- 3321A (24 pages)
- 4105A (10 pages)
- 4106 (48 pages)
- 4116A (20 pages)
- 4140 (32 pages)
- 4200 (24 pages)