KYORITSU 6310 Instruction Manual - Manual (Page 14)

1.2 Features KEW6310
1.3
KEW6310
1.2 Features
This is a Power Quality Analyzer that can be used for various wiring systems. It can be used for
simple measurements of instantaneous/ integration/ demand values, and also for monitoring
waveforms and vectors, analyzing harmonics and measuring the fluctuations in supply voltages and
can perform Capacitance Calculation. Data can be saved either in the internal memory or a CF card,
and can be transferred to a PC either via a USB lead or a CF Card reader.
Safety Construction
Designed to meet the international safety standard IEC 61010-1 CAT.III 600V/ CATII. 1000V
Wiring configuration
KEW6310 supports : Single-phase 2-wire, Single-phase 3-wire, Three-phase 3-wire, Three-phase 4-wire.
Measurement and caluclation
KEW6310 measures voltage (RMS), current (RMS), and calculates active/reactive/apparent power, power factor,
phase angle, frequency, neutral current and active/ reactive/ apparent electric energy. (RMS)
Demand measurment
Electricity consumption can be easily monitored so as not to exceed the target maximum demand values.
Waveform / Vector display
Voltage and current can be displayed by waveform or vector.
Harmonic analysis
Harmonic components of voltage and current can be measured and analyzed.
Power quality analysis
Measuring Swell/ Dip/ Int, Transient, Inrush current, Unbalance ratio and flicker*, moreover, simulating power
factor correction with capacitor banks.
* Flicker measurement function is only available with ver.2.00 or later.