KYORITSU 6310 Instruction Manual - Manual (Page 49)

KEW6310 4.2.1 Basic Setting
KEW6310
4.8
Setting for Clamp sensor
Model names and rated currents of Clamp sensors are listed as follows.
Clamp sensors for
Power measurement
Leakage Clamp sensor
8128 50A type 8141 1A type
8127 100A type 8142 1A type
8126 200A type 8143 1A type
8125 500A type 8146 10A type
8124 1000A type 8147 10A type
8129 3000A type 8148 10A type
* Default value (or after system reset) : 8125
* Clamp sensors for measurements other than power are available only at
following wiring configurations.
Number of available Clamp sensor depends on a wiring configuration to be measured.
① 1P2W×1 1ch
② 1P2W×2 1ch 2ch
③ 1P2W×3 1ch 2ch 3ch
④ 1P2W×4 1ch 2ch 3ch 4ch
⑤ 1P3W×1
⑧ 3P3W×1
1,2ch
⑥ 1P3W×2
⑨ 3P3W×2
System 1(1,2ch) System 2(3,4ch)
⑦ 1P3W×1+2A
⑩ 3P3W×1+2A
1,2ch 3ch 4ch
⑪ 3P3W3A
⑫ 3P4W×1
1,2,3ch
⑬ 3P4W×1+1A 1,2,3ch 4ch
4A 1ch 2ch 3ch 4ch
* Default value (or after system reset) : ⑩ 1,2,ch 3, 4ch
* Channels highlighted in light yellow are applicable only to Clamp sensors for
power measurement.
* Channels highlighted in gray are applicable to Clamp sensors for power
measurement and Leakage Clamp sensors.
0