KYORITSU 6310 Instruction Manual - Manual (Page 53)

KEW6310 4.2.1 Basic Setting
KEW6310
4.12
The instrument detects and checks the connected Clamp sensors and the selected wiring configuration, and
displays following messages when improper Clamp sensors are connected.
< Improper Clamp sensor is detected >
Recheck and connect proper Clamp sensors.
< No sensor is detected >
Check the Clamp sensor connected to the Current input terminal corresponding to the Ch number
displayed with question mark.
When starting measurement with the question mark displayed at the [Clamp] box, previous setting
is applied automatically.
Model names of the connected
Clamp sensors are displayed. Bars
are displayed at A range, CT ratio
and Filter boxes.
Question mark “?” is displayed at Model
name and Current range boxes. CT ratio is
automatically set to 1.00. Bars are displayed
at Filter box.
Question mark “?” is displayed at Model
name box.
CT ratio is automatically set to 1.00.
Bars are displayed at Filter box.