KROHNE OPTISONIC 6300 EN - Manual (Page 90)

6
OPERATION
90
OPTISONIC 6300
www.krohne.com 07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
C5.4.11 phase shift phase shift between output B and
D
0, 90, 180 degrees
C5.4.12 special function for ranging off, phase shift
C5.4.13 information serial number of circuit board,
software version, calibration date
of circuit board
C5.4.14 simulation simulation of pulse output on, off, cancel
C5.5 C5.5 C5.5 C5.5 status output status output status output status output
C5.5.1 mode output is activated if an error
occurs
(depends on pipe configuration: 1 or 2 pipes)
off, error in device, application error, out of
specification, empty pipe, polarity flow, over
range flow, application error 1 or 2, out of
specification 1 or 2, empty pipe 1 or 2, polarity
flow 1 or 2, over range flow 1 or 2, counter 1
preset, counter 2 preset, output A/B/C/D
C5.5.2 current output Y active if selected under status
output mode (C2.5.1) output Y and
output is current output
polarity, over range, automatic range
C5.5.3 frequency output Y active if selected under status
output mode (C2.5.1) output Y and
output is frequency output
polarity, over range
C5.5.4 pulse output D active if selected under status
output mode (C2.5.1) output Y and
output is pulse output
polarity, over range
C5.5.5 status output Y active if selected under status
output mode (C2.5.1) output Y and
output is status output
same signal, inverted signal
C5.5.6 limit switch Y active if selected under status
output mode (C2.5.1) output Y and
output is limit switch
off
C5.5.7 control input Y active if selected under status
output mode (C2.5.1) output Y and
output is control input
off
C5.5.8 off active if selected under status
output mode (C2.5.1) output Y and
output is switched off
off
C5.5.9 invert signal define status output activation off: activate high current/switch closed
on: low current/switch open
C5.5.10 information serial number of circuit board,
software version, calibration date
of circuit board
C5.5.11 simulation simulation of status output on, off, cancel
C5.6 C5.6 C5.6 C5.6 limit switch X limit switch X limit switch X limit switch X
C5.6.1 measurement measurement value to limit
switch
(depends on pipe configuration: 1 or 2 pipes)
volume flow, mass flow, VoS, flow speed, gain,
SNR, diagnosis value, volume flow 1 or 2, VoS 1
or 2
C5.6.2 threshold 1e: switch level 2e:time lag min-max: 500.0 - 2500 m/s
C5.6.3 polarity set polarity of limit switch positive -, negative -, both polarity(ies), absolute
value
C5.6.4 time constant within set time, measurements
are averaged, displayed and sent
to current output
min-max: 000.1 - 100.0
C5.6.5 invert signal define limit switch activation off: high current by exceeded limit
on: low current by exceeded limit
C5.6.6 information serial number of circuit board,
software version, calibration date
of circuit board
.book Page 90 Tuesday, August 18, 2009 4:51 PM