KROHNE OPTISONIC 6300 EN - Manual (Page 78)

6
OPERATION
78
OPTISONIC 6300
www.krohne.com 07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
6.2.3 Setup
C setup > ↑ ↓
(underneath C1 becomes active if two pipes two pipes two pipes two pipes are selected in X4)
C1 process input 1 > C1.1, C1.3,… ↑ ↓ ^
C1.1 number of pipes > read ^
C1.3 pipe data > C1.3.1 ↑ ↓
C1.3.1 pipe tag
(further submenus C1.3.2 up to C1.3.12 are identical to X6.2 up to X6.13)
C1.4 transducer data > C1.4.1,... ↑ ↓ ^
C1.4.1 transducer set > Ta,Tb,Tc,none ↑ ↓ ^
C1.4.2 number of
traverses
> 1,2,4 ↑ ↓ ^
C1.4.3 actual distance > fill in using ↑ ↓ > ^
C1.5 extra
measurements
> select on pipe 1,
on pipe 2
^
C1.6 calibration > C1.6.1, C1.6.2,… ↑ ↓
C1.6.1 zero calibration > calibrate zero ? select cancel,
automatic, default
C1.6.2 meter factor > fill in using ↑ ↓ > ^
C1.6.3 Reynolds
correction
> on,off ↑ ↓ ^
C1.7 filter > C1.7.1, C1.7.2,… ↑ ↓ ^
C1.7.1 limitation > fill in using ↑ ↓ > ^
C1.7.2 flow direction > normal/reverse ↑ ↓ ^
C1.7.3 time constant > fill in using ↑ ↓ > ^
C1.7.4 low flow cutoff > fill in using ↑ ↓ > ^
C1.8 simulation > C1.8.1, C1.8.2,… ↑ ↓ ^
C1.8.1 volume flow > set value/cancel ↑ ↓
start simulation ↑ ↓
yes/no ^
C1.8.2 vel. of sound > ↑ ↓
set value/cancel ↑ ↓
start simulation ↑ ↓
yes/no ^
C1.9 plausibility > C1.9.1, C1.9.2,… ↑ ↓ ^
C1.9.1 error limit > fill in using ↑ ↓ > ^
C1.9.2 counter decrease > fill in using ↑ ↓ > ^
C1.9.3 counter limit > fill in using ↑ ↓ > ^
C1.10 information > C1.10.1,
C1.10.2,…
↑ ↓ ^
C1.10.1 sensor CPU read
C1.10.2 sensor DSP read ^
C1.10.3 sensor driver read ^
C1.11 diagnosis value > fill in using ↑ ↓ > ^
C2 process input 2 > ↑ ↓
.book Page 78 Tuesday, August 18, 2009 4:51 PM