KROHNE OPTISONIC 6300 EN - Manual (Page 82)

6
OPERATION
82
OPTISONIC 6300
www.krohne.com 07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
C5.5.11 simulation > select set
on/off/cancel
^
C5.6 limit switch X > C5.6.1, C5.6.2,… ↑ ↓ ^
C5.6.1 measurement > select from list
using ↑ ↓
^
C5.6.2 threshold > fill in using ↑ ↓ > ^
C5.6.3 polarity > select from list
using ↑ ↓
^
C5.6.4 time constant > fill in using ↑ ↓ > ^
C5.6.5 invert signal > select on/off ^
C5.6.6 information > read ^
C5.6.7 simulation > select set
on/off/cancel
^
C5.7 control input X > C5.7.1, C5.7.2,… ↑ ↓ ^
C5.7.1 mode > select from list
using ↑ ↓
^
C5.7.2 invert signal > select on/off ^
C5.7.3 information > read ^
C5.7.4 simulation > select set
on/off/cancel
^
(active if HART device)
C6 I/O Counter > C6.1, C6.2 ↑ ↓
C6.1 counter 1 > C6.1.1, C6.1.2,… ↑ ↓ ^
C6.1.1 function of
counter
> select from list
using ↑ ↓
^
C6.1.2 measurement > select from list
using ↑ ↓
^
C6.1.3 low flow cutoff > fill in using ↑ ↓ > ^
C6.1.4 time constant > fill in using ↑ ↓ > ^
C6.1.5 preset value > fill in using ↑ ↓ > ^
C6.1.6 reset counter > select yes/no ^
C6.1.7 set counter > select set
on/off/cancel
^
C6.1.8 stop counter > select yes/no ^
C6.1.9 start counter > select yes/no ^
C6.1.10 information > read ^
C6.2 counter 2 > C6.2.1, C6.2.2,… ↑ ↓
(underneath submenus identical to C6.1.1 to C6.1.10)
C7 I/O HART > C7.1, C7.2,… ↑ ↓
C7.1 PV is > C7.1.1, C7.1.2,… ↑ ↓ ^
C7.1.1 current output A > read ^
(depends on I/O configuration)
C7.1.2 frequency output
X
> read ^
C7.1.3 HART dynamic
variable
> select from list
using ↑ ↓
^
C7.2 SV is > C7.2.1
C7.2.1 HART dynamic
variable
> select from list
using ↑ ↓
^
.book Page 82 Tuesday, August 18, 2009 4:51 PM