KROHNE OPTISONIC 6300 EN - Manual (Page 76)

6
OPERATION
76
OPTISONIC 6300
www.krohne.com 07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
6.2.2 Test
B1 simulation > B1.1, B1.2,… ↑ ↓
B1.1 volume flow > set value/cancel ↑ ↓
start simulation ↑ ↓
yes/no ^
(underneath B1.1 until B1.3 become active if two pipes or two paths two pipes or two paths two pipes or two paths two pipes or two paths are selected in X4 and X5)
B1.1 volume flow 1 > set value/cancel ↑ ↓
start simulation ↑ ↓
yes/no ^
B1.2 volume flow 2 > submenu
identical to B1.1
↑ ↓
(end)
B1.4 vel. of sound > set value/cancel ↑ ↓
start simulation ↑ ↓
yes/no ^
(underneath B1.4 until B1.5 become active if two pipes or two paths two pipes or two paths two pipes or two paths two pipes or two paths are selected in X4 and X5)
B1.4 vel. of sound 1 > ↑ ↓
set value/cancel
start simulation ↑ ↓
yes/no ^
B1.5 vel. of sound 2 > submenu
identical to B1.4
↑ ↓
(end)
B1.7 terminal A
(depends on IO
setting hardware)
> select from list
using ↑ ↓ >
^
B1.8 terminal B
(depends on IO
setting hardware)
> select from list
using ↑ ↓ >
^
B1.9 terminal C
(depends on IO
setting hardware)
> select from list
using ↑ ↓ >
^
B1.10 terminal D
(depends on IO
setting hardware)
> select from list
using ↑ ↓ >
^
B2 actual values > ↑ ↓
B.2.1 act. volume flow > ↑ ↓
(underneath B2.1.1 until B2.1.2 become active if two pipes two pipes two pipes two pipes are selected in X4 and X5)
B2.1.1 pipe 1 read ^
B2.1.2 pipe 2 read ^
(end)
B.2.2 act. mass flow > ↑ ↓
(additional menus for two pipes)
B.2.3 act. Reynolds nr. > ↑ ↓
(additional menus for two pipes)
B.2.4 act. vel. of sound > ↑ ↓
(additional menus for two pipes)
.book Page 76 Tuesday, August 18, 2009 4:51 PM