KROHNE OPTISONIC 6300 EN - Manual (Page 87)

OPERATION
6
87
OPTISONIC 6300
www.krohne.com 07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
A4.2 unit unit for HART current output L/s, L/min,L/h, m3/s, m3/min, m3/h, m3/d,
ft3/s, ft3/min, ft3/h, gal/s, gal/min,gal/h, gal/d,
IG/s, IG/min, IG/h, IG/d, bbl/h, bbl/d, free unit
A4.3 range range for main HART current
output
min-max: 0.00 - xxxx (depends on
configuration)
A4.4 low flow cutoff low flow cutoff for main HART
current output
min-max: 00.0 - 20.0
A4.5 time constant time constant for main HART
current output
min-max: 000.1 - 100.0
A5 A5 A5 A5 digital outputs digital outputs digital outputs digital outputs only active if HART device pulse output A, B or D, counter 1
A5.1 measurement value for pulse output (depends on pipe configuration: 1 or 2 pipes)
volume flow, mass flow, volume flow 1 or 2
A5.2 pulse value unit unit for main pulse output (unit class depends on selected measurement)
A5.3 value p. pulse value of pulse per volume or
mass for pulse output
(min-max depends on selected measurement)
A5.4 low flow cutoff low flow cutoff for pulse output (min-max depends on selected measurement)
B Test
B B B B test test test test
B1.7 terminal A (depends on IO setting hardware) current output A, frequency output A, pulse
output A, status output A, limit switch A, control
input A
B1.8 terminal B (depends on IO setting hardware) current output B, frequency output B, pulse
output B, status output B, limit switch B, control
input B
B1.9 terminal C (depends on IO setting hardware) current output C, status output C, limit switch C
B1.10 terminal D (depends on IO setting hardware) frequency output D, pulse output D, status
output D, limit switch D
B3.1 C number identification of electronics also see converter sticker;
first line: circuit board,
second line: software,
third line:calibration or production date
B3.2.1 Sensor CPU identification of hardware and
software for flow processing
also see sensor board of electronics
B3.2.2 Sensor DSP identification of hardware and
software for signal processing
also see sensor board of electronics
B3.2.3 Sensor driver identification of hardware and
software for driver part
also see sensor board of electronics
B3.3 Device identification of circuit board serial number of circuit board, main software
version number, production date
C Setup
C C C C setup setup setup setup
C1.5 extra
measurements
extra available parameters for
display or input/output
(only for dual pipe configuration: 1, 2 pipes)
on pipe 1: mass flow, flow speed, gain, SNR
on pipe 2: mass flow, flow speed, gain, SNR
C1.6.1 zero calibration transit time offset at zero flow cancel, default, automatic min-max: -10000 -
+10000 ps
C1.6.2 meter factor set factor for correction of
volume flow, mass flow, flow
speed and Reynolds number
min-max: 0.500 - 2.000
C1.6.3 Reynolds
correction
set Reynolds correction for flow
profile disturbances, effective on
volume flow, mass flow
on,off
.book Page 87 Tuesday, August 18, 2009 4:51 PM