KROHNE OPTISONIC 6300 EN - Manual (Page 56)

5
START-UP
56
OPTISONIC 6300
www.krohne.com 07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
Start-up
5.1 General instructions for programming
Human machine interface (HMI) Human machine interface (HMI) Human machine interface (HMI) Human machine interface (HMI)
Figure 5-1: Display and operating elements (Example: flow indication with 2 measuring values)
1 Indicates a possible status message in the status list
2 Tag number (is only indicated if this number was entered previously by the operator)
3 Indicates when a key has been pressed
4 1st measured variable in large depiction
5 Bargraph indication
6 Keys (see table below for function and depiction in text)
7 Interface to the GDC bus (not present in all signal converter versions)
8 Infrared sensor (not present in all signal converter versions)
Key Measuring mode Menu mode Sub-menu or function
mode Parameter and data
mode
> Switch from measuring
mode to menu mode;
press key for 2.5 s,
"quick start" menu is
then displayed
Access to displayed
menu, then 1st
submenu is displayed
Access to displayed sub-
menu or function
For numerical values,
move cursor
(highlighted in blue) one
position to the right
^ - Return to measuring
mode but first ask
whether the data should
be saved
Press 1 to 3 times,
return to menu mode,
data saved
Return to sub-menu or
function, data saved
↓ or ↑ Switch between display
pages: measured
value 1 + 2, trend page
and status page(s)
Select menu Select sub-menu or
function
Use cursor highlighted
in blue to change
number, unit, setting
and to move the decimal
point
Esc (> + ↑) - - Return to menu mode
without acceptance of
data
Return to sub-menu or
function without
acceptance of data
Table 5-1: Description of key functionality
.book Page 56 Tuesday, August 18, 2009 4:51 PM