GW Instek LCR-800 Series - Manual (Page 68)

APPENDIX
135
Table3
Y Range constant- Range Hold
Component
Inductor Capacitor Resistor
Range Max Min Max Min Max Min
Range1 16mH/f 1mH/f 25uF/f 1.6uF/f 100Ω 6.25Ω
Range2 256mH/f 16mH/f 1600nF/f 100nF/f 1.6kΩ 0.1kΩ
Range3 4100mH/f 256mH/f 100nF/f 6.4nF/f 25.6kΩ 1.6kΩ
Range4* 65H/f 4.1H/f 6400pF/f 400pF/f 410kΩ 25.6kΩ
f= test frequency in kHz
* This range is not used above 20 kHz
Table4
Y Range constant- Auto Range
Component
Inductor Capacitor Resistor
Range Max Min Max Min Max Min
Auto range 65H/f** 1mH/f 25uF/f 400pF/f ** 410kΩ** 6.25Ω**
**: Above 20kHz, Cmin = 6.4 nF/f, and Lmax = 4100mH/f
f = test frequency in kHz.
LCR-800 User Manual
136
Specifications
Specification accuracy is only applicable when the LCR meter has
been warmed up for 30 minutes with an operating temperature of
18°C ~28°C.
Measurement
Parameters Inductance (Ls/Lp)*, Capacitance (Cs/Cp), Resistance
(Rs/Rp), Dissipation (D), Quality Factors (Q),
Equivalent Series Resistance (ESR) and Equivalent
Parallel Resistance (EPR), Impedance (|Z|), Phase
angle of Impedance [degree] (θ).
Measurement
Modes R/Q, C/D, C/R, L/Q, Z/ θ, L/R
Display Ranges Primary
Display Inductance
(L) 0.00001mH ～ 99999H
Capacitance
(C) 0.00001pF ～ 99999μF
Resistance
(R) 0.00001Ω ～ 99999kΩ
Absolute of
Impedance
(Z)
0.00001Ω ～ 99999kΩ
Secondary
Display Dissipation
factor (D)
+
0.0001 ～ 9999
Quality
factor (Q)** 0.0001 ～ 9999
Phase angle
of
Impedance
(degree) -180.00∘ ～ 180.00∘
Equivalent
Series
Resistance
(ESR)
+
0.0001Ω ～ 9999 kΩ
Equivalent
Parallel
Resistance
(EPR)
+
0.0001Ω ～ 9999 kΩ