GW Instek LCR-800 Series - Manual (Page 56)

INTERACE
111
I
NTERACE
This chapter describes basic interface aspects of
the RS-232 and Handler interfaces.
RS232 Interface
Configuration Configure RS-232 interface ....................................... 112
Handler interface ...................................................... 114
Signal
Characteristics Signal Overview ........................................................ 116
Handler Timing ......................................................... 119
LCR-800 User Manual
112
RS232 Interface Configuration
Configure RS-232 interface
RS-232
configuration Connector DB-9, Male
Baud rate 38400 (default)
Parity None
Data bit 8
Stop bit 1
Connect the RS-232 cable to the
rear panel port: DB-9 male
connector.
Pin assignment 1 2 3 4 5
6 7 8 9
1: DCD (Data Carrier Detect)
2: RxD (Receive Data)
3: TxD (Transmit Data)
4: DTR (Data Terminal
Ready)
5: GND
6: DSR (Data Set Ready)
7: RTS (Request To Send)
8: CTS (Clear To Send)
9: No connection