GW Instek LCR-800 Series - Manual (Page 15)

BASIC MEASUREMENT
29
B
ASIC MEASUREMENT
Basic Measurement details how to measure
individual components and how to configure the
LCR-800 settings. Basic Measurement also
describes how to save and recall memory.
Advanced functions such as the handler menu or
remote control are detailed on page 48 and 72,
respectively.
Measurement
Description
Measurement Item Description ................................. 30
Measurement combination ........................................ 30
Display overview ......................................................... 30
Configuration
Parameter Configuration .............................................31
Measurement Speed....................................................31
Select equivalent circuit type ...................................... 33
Set Bias voltage ........................................................... 34
Set measurement frequency ....................................... 35
Set measurement voltage ........................................... 37
Set PPM for D/Q measurements ............................... 38
Set constant voltage source ....................................... 39
Set Range hold ............................................................ 40
Set Average ................................................................. 40
Set Nominal Values .....................................................41
Measurement
Running Measurement ............................................... 43
Select Single measurement ........................................ 43
Select Automatic measurement ................................. 44
Store/Recall
Store Recall ................................................................. 45
Store or Recall Memory Settings ................................ 45
Recall Calibration Settings.......................................... 46
LCR-800 User Manual
30
Measurement Item Description
In general, two measurement items, primary and secondary, are
combined in a single measurement. The following table shows the
available combinations. Details of the measurement modes and the
circuit theory and formula can be found in the appendix, page 124.
Measurement combination
:Available, :Not available
1st measurement 2nd measurement Circuit model
Q D R θ Series Parallel
Capacitance (C)
Inductance (L) *
Impedance (Z) *
Resistance (R)
*LCR-821
Display overview
Normal mode