Yokogawa YFGW710 - Manual (Page 90)

B1-26
IM 01W01F01-01EN
n Auto Checking
When changes are made to the project database, the checkboxes for the information, to which
a change was made and which therefore needs to be downloaded, are automatically checked
in the Download Project Data window. Write the information to YFGW710 without clearing the
check marks.
Table B1-11 Auto Checking
Item
(refer to Figure B1-7)
Description of change Remark
IPv4 Settings
(requires restart)
(1) When changing the [IPv4 Settings] infor-
mation under the [Network Information] tab
YFGW710 automatically restarts during
the download.
When the IP address of YFGW710 is
changed, the download to all the devices is
performed automatically. Refer to Devices.
Gateway
(requires restart)
(1) When changing the Network ID
(2) When changing the Gateway information
under the [Network Information] tab
System Manger
(requires restart)
(1) When changing the Network ID
(2) When changing the [System Manager/
Security Manager] information under the
[Network Information] tab
Device Provisioning
(Security Manager)
(1) When changing the device tag
(2) When EUI-64 and join key of the device in
question are changed as a result of regis-
tering the provisioning information from the
provisioning information file
(3) When changing the device role
When adding or deleting a device, or
changing the device tag and device role, or
updating the provisioning information, this
information needs to be downloaded.
However, YFGW710 does not restart
automatically during the download. Online
operation is possible.
Backbone Router
(requires restart)
(1) When changing the Network ID
(2) When changing the [Backbone Router]
information under the [Network Informa-
tion] tab
YFGW710 automatically restarts during
the download.
Modbus Register Map
and Pub/Sub communica-
tion
(1) When performing Load CF/DD
(2) When changing the information in [Sam-
pling data] in the Edit Device window
(3) When changing the Modbus Register map
YFGW710 does not restart automatically
during the download. Online operation
is possible. However, communication
between the device to be changed and
YFGW710 is stopped temporarily.
Devices (1) When changing the IP address in [IPv4
Settings] under the [Network Information]
tab
(2) When performing Load CF/DD
(3) When changing the information in [Sam-
pling data] in the [Edit Device] window
(4) When the device role is changed