Yokogawa YFGW710 - Manual (Page 180)

C3-26
IM 01W01F01-01EN
4) When the command is executed, the Command Results window will display the results of
the command in the Response section. The response will be indicated as “success” if the
command was executed successfully or the cause of the error will be shown if the command
failed.
Figure C 3-24
IMPORTANT
There may be a case that Power Supply Status is not updated after replacing the battery pack
of the device. Perform Warm Restart command to the device in order to reset the Power Supply
Status with >75% display.
TIP
Reset the remaining battery power calculation by Reset Energy Left parameter of the device before replacing the
battery pack. For details of field wireless devices, refer to the user’s manual of the respective devices.