Yokogawa YFGW710 - Manual (Page 135)

C2-14
IM 01W01F01-01EN
B) Sampling Data Tab:
The left pane displays the list of data which can be sampled using the selected device, while
the right pane displays the data to be sent from the device, and data transmission param-
eters such as transmission cycle, etc. (Figure C2-13).
Use the four buttons , , , to set data transmission parameters from
the Available Parameters list to the Sampling Parameters list: add the selected parameter,
add all parameters, remove the selected parameter, or remove all parameters from the
Sampling Parameters list.
Once you add a parameter to the Sampling Parameters list, the parameter will be displayed
as disabled in the list of the Available Parameters field, so that it cannot be added again to
the Sampling Parameters field.
Figure C 2-13
• If an UAP has more than one concentrator object *1 , only the first one will be enabled and the
other concentrator objects will be displayed in the right pane as disabled.
• If an UAP has no concentrator object defined, the sampling data cannot be defined.
• If you try to remove a parameter from the Sampling Parameters list, the application will
verify if the parameter is used in the Modbus Configuration register map, and if so, it will
request confirmation for removing the parameter from the sampling list.
• The Publication Time and Stale Limit Time values are automatically filled with default values.
The values can be changed, but if the StaleLimitTime value is smaller than the Publication
Time value, an error message will be displayed.
• When all parameters are cancelled from the [Sampling Parameters] field and the device role
of the device is IO or IO + Router, the device data will not be published.
*1: The concentrator object is an aggregate of operation paremeters of data Publish.
After setting all data in the two tabs, click [OK] at the bottom of the Device Information tab page to
save the changes on the current project session.