Yokogawa YFGW710 - Manual (Page 132)

C2-11
IM 01W01F01-01EN
C2.3.3.4 Creating a Project
To create a new project, click New Project in the File menu or click in the toolbar.
n Adding a Network
To add a network, select the Network node in the Project Sections tree, then click of tool bar in
the Section Data area (right pane). The new network is added to the Networks tree and its set-
tings can be edited.
You can add as many networks as you wish by repeating the operation.
l Network Information Tab
When you add a network or select a network ID in the Project Sections tree, the Network Infor-
mation tab page will be displayed in the Section Data area. The Section Data area consists of
three tabs: Network Information, Devices and Modbus configuration.
The Network Information tab allows you to manage information for the network and its major
components - Gateway, System Manager, Security Manager, and Backbone Router (they are a
part of the YFGW 710 function block) - and includes the following sections:
• Network Information: Indicates the Network ID and allows you to provide a custom descrip-
tion of the selected network
• IPv4 Settings: Sets the connection information of IP address, etc.
• Gateway: Sets the gateway tag
• System Manager/Security Manager: Sets the System Manager tag, EUI-64 address, trans-
mission channels, network topology, and transmission related settings
• Backbone Router: Sets the backbone router tag, filter bit mask, and filter target ID
Figure C 2-10