Yokogawa YFGW710 - Manual (Page 185)

C3-31
IM 01W01F01-01EN
3) Get Radio Firmware Update Status
This command allows you to view the status of ongoing firmware updates.
1. Select the Get Firmware Update Status command in the Firmware Commands drop-
down list. The Get Firmware Update Status window opens, with the EUI-64 address list
set to the device in the Devices tab page. Select device to execute the command at the
window.
Figure C 3-31a
2. To execute the command, click [OK]. The Command Results window shows the result
of the operation in the response column.
The command returns the following responses:
• Update in progress, and the update percentage.
• Success
• Firmware update done
• Cancel done
• No active firmware update
• Applying not confirmed: When the applied Firmware Update command does not
receive a response
• Cancel not confirmed: When a applied Cancel command does not receive a re-
sponse
• Fail
The Installation procedure or update procedure from older version is described in the Re-
adme_en.txt contained on the DVD-ROM.
If Microsoft .NET Framework 3.5 Service Pack 1 is not installed, install it according to the
instructions given in the TIP below.
Follow the instructions in the TIP of “C1. System Requirements of Provided Software” to
check if Microsoft .NET Framework 3.5 Service Pack 1 is enabled under Windows Server
2008 R2.
4) Updating sensor board firmware
The Update Sensor Board Firmware command allows you to update the firmware of a sen-
sor board in a field wireless device.
Sensor board firmware updating procedure
1. From the firmware command dropdown list, select the Update Sensor Board Firmware
command.
The [Update Sensor Board Firmware] window opens.
2. In this window, select the EUI-64 address of the device you want to start updating the
firmware of. You can only select one type of device for each update operation.
3. Click [Browse] to select the update file package of the sensor board firmware for the
selected type of device and click [Open].