Yokogawa YFGW710 - Manual (Page 186)

C3-32
IM 01W01F01-01EN
4. Change the Committed Burst value if required. For details on the meaning of the differ-
ent values, refer to the TIP.
Use the -15 default value for normal updates.
5. To start an update, you will be requested to make a confirmation. Click [OK] to start the
update or click [Cancel] to abort it.
6. When the command is sent, the message “The command has been successfully sent.
Check Commands Log” appears.
7. The sent command and the “Upload started” response are indicated in the command
log.
TIP
When multiple devices are selected, the system runs the command separately for each device. The command
log lists the commands and provides each with its own tracking number.
Figure C3-31b
TIP
The Committed Burst value defines the bandwidth of communications other than periodic communications.
A positive value indicates the number of packets sent per second. (For example “2” guarantees that 2 packets are
sent every second.)
A negative value indicates the time it takes to send a packet. (For example “-15” guarantees that 1 packet is sent
in 15 seconds.)